If the engine is warm and fails to start, open the throttle slightly and try to start the engine again.If you have any question about the operation or maintenance of your outboard motor, please consult a Yamaha dealer.
Yamaha 60 Hp Outboard Service Manual Particularly ImportantIn this Owners Manual particularly important.Attach the engine stop switch lanyard cord Yamaha recommends consulting the deal- to a secure place on your clothing, or your er on discarding the product.
This means that ter vessels, the operator should sound a pro- red buoys are passed on the starboard longed blast on the whistle (4 to 6 seconds). If another vessel is around the bend, it too ter into port, and black buoys are to port (left). Yamaha 60 Hp Outboard Service Portable Fuel TanksRefuel GASOLINE AND ITS VAPORS ARE HIGH- portable fuel tanks off the boat. When constant speed is desired, tighten the adjuster to maintain the desired throttle set- ting. EMU25990 Engine stop lanyard switch 1. Lanyard 2. Lock plate The lock plate must be attached to the en- gine stop switch for the engine to run. The power trim and tilt system adjusts the (off) outboard motor angle in relation to the tran- With the main switch in the. Power trim and tilt switch Power trim and tilt switch on bottom engine cowling NOTE: The power trim and tilt switch is located on For instructions on using the power trim and the side of the bottom engine cowling. Bolt To remove the engine top cowling, turn the lock lever(s) and lift off the cowling. When in- EMU26261 Trim rod (tilt pin) stalling the cowling, check to be sure it fits The position of the trim rod determines the properly in the rubber seal. NOTE: The water separator and engine trouble warning indicators only operate when the en- gine is equipped with the appropriate func- tions. ZMU04581 NOTE: ZMU01867 Memorize the trim angles that work best for 1. Adjust the trim angle to the desired setting with the EMU26581 Overheat warning indicator (digital power trim and tilt switch. Consult your Yamaha dealer if the problem can- not be located and corrected. EMU26814 Overheat warning This engine has an overheat warning device. Installation EWM00830 ECM00110 WARNING CAUTION: Improper mounting of the outboard mo- Incorrect engine height or obstructions tor could result in hazardous conditions to smooth water flow (such as the design such as poor handling, loss of control, or or condition of the boat, or accessories fire hazards. Con- wise the engine could be completely lost sult your Yamaha dealer boat if it accidentally falls off the transom. For details, consult EMU27060 Gasoline and engine oil mixing chart your Yamaha dealer. EWM00650 WARNING Avoid using bolts, nuts or washers other than those contained in the engine pack- aging. If used, they must be of at least the same quality of material and strength and must be tightened securely. Yamaha 60 Hp Outboard Service Free Fuel AddiRing Free Fuel Addi- 25 L (6.60 US gal) (5.50 Imp.gal) tive has repeatedly proven its ability to clean combustion deposits from inside the engine, notably the critical piston-ring-land area, and fuel system components. This engine uses the Yamaha oil injection system, which provides superior lubrication by ensuring the proper oil ratio for all operat- ZMU03370 ing conditions. Squeeze the primer pump with the outlet end up until you feel it become firm. ZMU02295 If there is a fuel joint on the motor, firmly connect the fuel line to the joint.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |